In Armor Alley
you pilot a helicopter through side-viewed terrain. Your job is to take out the enemy forces and their base, initially armed with missiles, bombs and machine guns. Watch out for enemy anti-aircraft balloons.
However the game differs from most Choplifter
style games by involving management of a squad. You have tanks, explosive vans, engineers and infantry units which can be ordered from the base, and must then be protected from enemy fire. Supplies are limited by financial constraints, as every unit and weapon has a price.
The Press Says
There are currently no topics for this game.
The game was developed for the black and white screen of the Mac Classic as well as the more colorful screen of the Mac LC, and these graphics were ported over to the PC, making Armor Alley
one of the only games ever released for the PC to support EGA's Monochrome graphics mode. Unfortunately, the Mac Classic's 512-pixel-wide screen also carried over; the game's playfield is 512 (or 256, if in low res) pixels wide, wasting 128 pixels every scanline.
was one of the few cross-platform games that had true cross-platform networked multiplayer options. A Mac and a PC could play against each other, for example.
The game supported multiple modems-to-modems networking years before Kali, etc. existed. Players could fight someone over CompuServe by going to a specific forum, making a connection with another gamer, then existing the dos-based CompuServe terminal program without dropping the line and starting up Armor Alley
. Following are the details of this (long defunct) service, which was way ahead of it's time:
Playing Armor Alley over CompuServe
Finding someone to enjoy a multi-player game of Armor Alley may prove
difficult at times. CompuServe has an answer, their Modem-to-Modem
(MTM) gaming area. This area allows users to meet and play multiple
player games thru the CompuServe network. In addition, the cost is
attractive, at $6 per hour, compared to long distance phone bills.
This MTM area supports Armor Alley at 1200 and 2400 baud rates. To use
this area you will need to have a CompuServe ID (see above) and a modem
program capable of quitting without hanging up the phone. Follow the
steps below to play Armor Alley thru CompuServe...
- Using your terminal program, connect to CompuServe.<
- At CompuServe's main menu prompt (or at any ! prompt thereafter)
type the command: GO MTMGAMES
- Use option #3 to enter the MTM gaming lobby.
- Once in the lobby, type the command: /U (Note: someone is always
available to help you in the MTM area from 7pm-12am EST.)
- From the list of users shown, see if any have Armor Alley as the
game they wish to play. If there is, type the command: /CHALLENGE #
(where # is the user # of that person). Now, wait for that person to
either accept or decline your challenge.
- If not, type the command: /GAME Armor Alley and wait for another
person to challenge, or until someone challenges you. If they do you
will get a notice with their user number. To accept type: /ACCEPT # (#
being their user #)
Once a challenge has been accepted both users will be informed, and told
to switch to Armor Alley after the system is ready. To do so, exit your
terminal program, without hanging up the line (dropping carrier). Run
Armor Alley and select a direct connect game, using the port your modem
is connected to. Be sure to select the baud rate you connected to
CompuServe with, either 1200 or 2400. Then wait for two-three minutes
so the other person can do the same and Armor Alley can sync up. You
can then start a new game and play! (See page 34)
Macintosh users only-Using MultiFinder and a MultiFinder capable term
program, be sure to run Armor Alley before connecting to CompuServe.
Then, simply switch to Armor Alley and select a direct connect game.
This game was originally released for the Apple II in 1984 under the name Rescue Raiders
was a larger success on the Macintosh than the PC.Information also contributed by